ELICA EFG630S1 Installation Guide download pdf (Page 9)

Control

1 2 3 4 5 6

1. Button ON/OFF motor (stand by)

2. Button for low speed (suction power) selection

When ﬂashing, it indicates that you must wash the grease ﬁlter.

3. Button for medium speed (suction power) selection

4. Button for high speed (suction power) selection

5. Button for intensive speed (suction power) selection

It lasts 5 minutes then it returns to medium speed (suction power).

6. Button ON/OFF lighting

Press brieﬂy to switch on or o the lighting of the hood.

Press and hold to adjust the intensity of the light.

Indicators of filter saturation:

At regular time intervals, the hood indicates the need of

performing filter maintenance.

Button

on with steady light:

Perform grease filter maintenance.

Button flashing:

Perform activated charcoal filter maintenance.

NOTE: Filter saturation signal is visible within the first minute

after switching off the hood; within this time, the reset of

saturation indicators must be performed.

Reset of filter saturation indicators:

Press and hold the button

Activation of saturation indicator activated charcoal filter:

NOTE: This operation must be performed with the hood off.

This indicator is normally deactivated; press and hold the

button

to activate the function: the button lights up with

steady light.

To deactivate the function, press and hold the button

the button lights up flashing.

CFM Reduction System

Before operating your hood:

Some States and Provinces of the US & Canada restrict the

maximum exhausting airﬂow of range hoods. Airﬂow is measured

as cubic feet per minute (CFM). These maximum levels allowed

are detailed in the local code of your area. Please check local

codes to ﬁnd out if you need to restrict the maximum airﬂow

of your hood. If your local code mandates a maximum airﬂow

level below the maximum airﬂow of this hood (i.e. 600 CFM),

please execute the procedure below to reduce the maximum

airﬂow.

1 Turn the motor OFF.

2 Press the ON/OFF (1) and Intensive speed (5) buttons

together for 3 seconds.

You will hear a beep and all control lights will illuminate

for 3 seconds.

This action will Disable speeds 3 and 4 and eectively

lower the Maximum airﬂow to > 300 CFM.

3 Locate the CFM certiﬁcation sticker in the hardware pack.

4 Peel and Ax this sticker to a visible area in the blower.

This sticker provides ocial certiﬁcation to your local

inspector that this hoods maximum airﬂow has been

reduced to > 300 CFM.

Maintenance

Cleaning

Do not spray cleaners directly to the control while cleaning the

Hood. The cooker hood should be cleaned regularly (at least

with the same frequency with which you carry out maintenance

of the fat ﬁlters) internally and externally. Clean using the

cloth dampened with neutral liquid detergent. Do not use

abrasive products.

DO NOT USE ALCOHOL!

I WARNING:

Failure to carry out the basic cleaning recommendations of the

cooker hood and replacement of the filters may cause fire risks.

Therefore, we recommend oserving these instructions.

The manufacturer declines all responsibility for any damage to

the motor or any fire damage linked to inappropriate maintenance

or failure to observe the above safety recommendations.

Grease Filter

Traps cooking grease particles.

This must be cleaned once a month using non aggressive

detergents, either by hand or in the dishwasher, which must be

set to a low temperature and a short cycle. When washed in

a dishwasher, the grease filter may discolour slightly, but this

does not affect its filtering capacity.

To remove the grease filter, pull the spring release handle.

A. Spring release handle

Replacing a LED Lamp

The LED lights are replaceable by a service technician only.

See “Who to contact” section in the warranty for service

contact information.

Charcoal ﬁlter

I WARNING

To reduce the risk of ﬁre and shock use only the carbon ﬁlter kit

KIT02766

If the model is not vented to the outside, the air will be

recirculated through disposable charcoal filters that help

remove smoke and odors.

1 Cover the grill that protects the suction motor with the

carbon ﬁlter so that the slots on the ﬁlter correspond to

the pins on the sides of the motor protection grill.

2 Turn the carbon ﬁlter clockwise to block them (bayonet

ﬁxing).

NOTE: The charcoal filters cannot be cleaned. It should be

replaced every 4-6 months (depending on hood usage).

NOTE: DO NOT rinse, or put charcoal filters in an automatic

dishwasher.

NOTE: Charcoal filters are not included with the hood. They

must be ordered from your supplier. Order the needed kit

specifying your hood model and width size.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

ELICA EFG630S1 Installation Guide Page 9

Comments to this Manuals

Related products and manuals for Cooker hoods ELICA EFG630S1