ELICA EFG630S1 Installation Guide download pdf (Page 6)

Ducting Options

Closely follow the instructions set out in this manual.

All responsability, for any eventual inconveniences, damages or ﬁres caused by not complying with the instructions in this

manual, is declined.

Ducting version Ductless (Recirculating)

The hood is equipped with a 6” (15.2 cm) round transition

for discharge of fumes to the outside.

Roof Venting Wall Venting

A. Roof cap

B. 6” (15.2 cm) round vent

A. Wall cap

B. 6” (15.2 cm) round vent

In cases where it should not

be possible to discharge

cooking fumes and vapour

to the outside.

Attach a charcoal ﬁlter and

the deﬂector on the duct

cover support bracket.

Fumes and vapours are

recycled through the top

grille by means of a duct

connected to the transition

and the transition mounted

on the deﬂector.

For this version only:

purchase the Ductless

Recirculating Kit.

Minimum Duct Size:

6” Round Pipe.

A. Deﬂector

B. 6” (15.2 cm) round vent

Preparation

Do not cut a joist or stud unless absolutely necessary. If a joist

or stud must be cut, then a supporting frame must be

constructed.

Fittings material is provided to secure the hood to most types

of walls/ceilings.

However, a qualiﬁed technician must verify suitability of the

materials in accordance with the type of wall/ceiling.

Before making cutouts, make sure there is proper clearance

within the ceiling or wall for exhaust vent.

I CAUTION

Mount this hood so that the bottom edge above the cooking

surface is at 30” (76.2 cm) minimum if a gas range is used, or

at 27” (68.6 cm) if an electric range is used.

There is no maximum mounting height, however, we recommend

mounting the hood no greater than 36” (91.4 cm) above the

cooking surface. For every inch (2.54 cm) above 36” (91.4 cm),

increasing rate and may not deliver an acceptable level of

ventilating performance.

This hood is intended for household use.

PLEASE READ THE INSTALLATION SECTION FOR SPECIFIC

APPLICATION. Check your ceiling height and hood height

before selecting your hood.

Installation

Prepare location

• It is recommended that the vent system be installed before

hood is installed.

• Before making cutouts, make sure there is proper clearance

within the ceiling or wall for exhaust vent.

• Check your ceiling height and the hood height maximum

before you select your hood.

1 Disconnect power.

2 Determine which venting method to use: roof, wall, or

nonvented.

3 Select a ﬂat surface for assembling the range hood.

Place covering over that surface.

I WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR

INJURY TO PERSONS, OBSERVE THE FOLLOWING.

4 Using 2 or more people, lift range hood onto covered

surface.

Mounting the duct cover bracket

1 Determine and mark the centerline on the wall where the

canopy hood will be installed. Disconnect power.

2 Tape template in place, aligning the template centerline

and bottom of template with hood bottom line and with

the centerline marked on the wall.

A. Centerline

B. Fastener locations

C. Mounting height reference (hood bottom line)

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comments to this Manuals

No comments

ELICA EFG630S1 Installation Guide Page 6

Comments to this Manuals

Related products and manuals for Cooker hoods ELICA EFG630S1