Elica OM User Manual download pdf (Page 13)

– filtering version).

• Mount the grease filter and close the steam screen.

Attention! If the hood is to be used in the suction

version, remove, if supplied with the kit, the carbon filter

and the fixing rods (on the back of the grease filter – see

relative paragraph).

If the hood is to be used in the filtering version, check

that the carbon filter is already mounted on the back of

the grease filter or, in its absence, purchase it and install

it.

• Connect the hood to the general electric panel, wait for

about 15 seconds to allow the hood to calibrate the

control panel (the leds of the controls flash) and check

the functioning.

Description of the hood

Fig. 1

1. Control panel

2. Grease filter

3. Grease filter release handle

4. Lighting

5. Vapour catcher

6. Air outlet

7. Telescopic chimney

The steam screen must always be left closed and opened only

for maintenance (e.g. cleaning or changing filters).

Operation

Use the high suction speed in cases of concentrated kitchen

vapours. It is recommended that the cooker hood suction is

switched on for 5 minutes prior to cooking and to leave in

operation during cooking and for another 15 minutes

approximately after terminating cooking.

To select the functions of the hood just touch the

commands.

Light key ON/OFF

Intensive speed selection key (suction

power) - duration 5 minutes - press again to

return to previous setting.

High-speed selection key (suction power).

Medium-speed selection key (suction power)

- when flashing it indicates the need to wash or

replace the carbon filter. This signal is normally

deactivated. Press keys 1 and 2 at the same

time to activate it. At first only key 1 will flash

and then both keys 1 and 2 to indicate

activation. Repeat the operation to deactivate

the signal. At first keys 1 and 2 will flash and

then only key 1 to indicate deactivation.

Low-speed selection key (suction power) –

when flashing it indicates the need to wash the

fats filter.

Motor key OFF (stand by) – excludes the

electronics – reset wash/replace filters

signals.

MOTOR OFF

Press briefly to switch the motor off.

RESET FILTERS SIGNALS

fter having carried out maintenance of the

filters, press the key for 3 seconds.

Flashing led 1 (fats filter) or 2 (carbon filter)

will stop flashing.

EXCLUDING THE ELECTRONICS

Press the key for 3 seconds. The hood

command electronics will be excluded.

This function can be useful during the

product cleaning operations.

Just repeat the operation to reinsert the

electronics.

If the hood fails to operate correctly, briefly disconnect it

from the mains power supply for almost 5 sec. by pulling

out the plug. Then plug it in again and try once more

before contacting the Technical Assistance Service.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 79 80

Comments to this Manuals

No comments

Elica OM User Manual Page 13

Comments to this Manuals

Related products and manuals for Hoods Elica OM